檢測認證人脈交流通訊錄
- 一．技術參數Technical parameters
吹灰角度
Sootblowing range 90°—360°
吹灰槍轉速
Potating speed of lance tube 2.5 r..P.m
每次吹掃圈數
Each time blows sweeps the turn 1圈或2圈（根據要求調整）
1 turn or 2 turn
最大吹灰半徑
Effective blowing radius 1~1.5m
吹灰介質
Blowing medium 蒸汽或壓縮空氣
Steam or compressed air
吹灰介質壓力
Blowing pressure 0.78~1.96MPa
吹灰介質耗量
Blowing steam consumption 30~100kg/min
電動機型號規格
Motor specification YSR—6324 B5型180W
1400r.P.m 380V 50Hz 3P
吹灰器重量
Weight ~75kg
二．產品特點 Product feature
(1) 結構合理緊湊
Composition Suitability
(2) 空心抽與閥門間的轉動密封結構
Sealing composition of shaft and valve
(3) 接墻密封裝置能有效地進行密封
Effective sealing result of sealing seat system
(4) 吹灰器滿足0~360°全方位吹掃
Blow in 0°~360° degrees range
三．適用范圍Applicable scope
G3A-G9設計用于清掃固定式鍋爐、船用鍋爐、余熱鍋爐和油爐的受熱管表面的灰渣，安裝在其內部溫度低于吹灰槍管許用溫度的區域。G3A-G9也可用于清掃大型鍋爐的低溫煙氣區域，包括再熱器、省煤器、煙氣循環和除塵器區域。
多噴嘴組件可用于分道吹灰和整體吹灰，以便更好地清潔鍋爐管表面區域。根據吹掃部位煙溫具體情況，吹灰槍管采用不同的材料。G3A-G9吹灰器每次吹灰時只需啟動一次，吹灰槍管旋轉，同時控制閥門開啟與關閉。G3A-G9吹灰器可改裝成不旋轉式吹灰器，用于吹掃某些有特殊要求的固定裝置，如風道、引風機和其它特種鍋爐
The G3A-G9sootblower is designed to remove ash deposits from tube surfaces in stationary boilers, marine boilers, waste heat boilers and direct-fired oil-heaters, where gas temperature zones inside the boiler permit a fixed cleaning element. The G3A-G9may also be used for cleaning low-temperature gas zones in large boilers, including reheaters, economizers, and gas recirculation and precipitator ducts.
A multi-nozzled element is used in a lane blowing or mass blowing configuration for complete cleaning of the boiler tube surface area. Four element materials are available for different temperature requirements. The G3A-G9 blower requires only one operation to rotate the blowing element and simultaneously open and close the supply valve.
